So, I was trying to think of something to get my dad for father’s day and I ran across these key chains that hold guitar picks. Since he plays guitar, I thought about buying one for him… but decided that it was something that I could make and it would be cooler if I made it myself. This is my first time making anything out of leather, so if it doesn’t look super professional… give me a break.
I started out by outlining a pick and then folding the paper and tracing that, so there were two picks exactly opposite each other with a small space between them. Then I drew lines around them, giving what I thought was enough room to stitch leather so that the picks would fit in the little pocket it created. Once side doesn’t go all the way around, so the picks can easily be removed. The other has a strap so that a key-ring can be attached and the pick-pocket can be closed.
Once I had my design cut out, I folded it up to see if everything would work. Would picks fit inside and would the strap be long enough to accommodate a key ring and reach the pocket? Everything looked good, so I traced it onto a piece of leather. Then I cut out the leather using a scissors.
Next I folded up the pocket portion of the key chain and started sewing it together with sinew. I started in between the folds, so that the knots would be hidden. Then I started sewing along one side and along the bottom. I kind of doubled back on my stitches so that each seam was sewn twice. When I got to the bottom, I stopped so I could install a snap. I would have actually done that first, but I didn’t have my stuff handy, so when I got to that point I stopped until I got the snap installed.
Snaps are usually super easy to install. For the ones I was using there’s a spiked ring that you push through the fabric. The other part of the snap sits on top of that, and using a little tool you hit it with a hammer to drive in and bend those spikes. With leather it’s a bit more difficult to get those spikes through the “fabric” so I folded up a scrap of leather and using the side of a knife pushed the ring forcing the spikes through the leather (and into the leather underneath). Once I had the spikes pushed though, I installed the snap like normal. (Again, I didn’t do any measuring and got the snap off-center on the pocket… but everything still works fine.)
I put the female side on the pocket, then installed the male part on the strap, using the same method.
Now all that was left was to finish sewing. I finished sewing up the one remaining side of the pocket, and then went to work on the strap. I stuck the strap through a key ring, and then snapped it to the pocket. I held the key ring where the strap would sit flat when folded and then sewed a line underneath it to hold the ring in place. Again I started inside the fold to hide the knots. Also, I didn’t sew around the edge of the leather because the edge sees a lot of wear and I was worried that the thread/sinew would get worn through and then come unraveled.
I finished that seam, tied off the sinew and test fit the 3 guitar picks I had handy. There was plenty of room for them, maybe even one or two more.